Do you know the connection method of steel rope conveyor belt?

2022-06-20

Everyone has heard of wire rope conveyor belts at some point. In daily work, joints are essential. Do you know how to connect a steel cable conveyor belt? Next, let us show you all!
The commonly used methods of conveyor belt joints include mechanical joints, cold bonding joints, hot vulcanization joints, etc. Mechanical joints generally refer to the use of belt buckle joints, which are convenient, fast and economical. Cold-bonded joints use cold-bonded adhesives for joints, which are both efficient and economical, and should have better joint effects. The hot vulcanized joint can ensure high joint efficiency, and it is also very stable, the joint life is also very long, and it is easy to master.
Install the vulcanizer first, place the lower frame, align the two ends, and align the center line of the frame with the center line of the wire rope conveyor belt. After the gluing part of the steel cord conveyor belt is made according to the process, clamp the two sides of the gluing part with plugs, place the vulcanized board, the water pressure board and the upper insulation board in sequence, and then place the frame on the frame, and the center line is aligned with the steel wire Install the connecting bolts on the center line of the cord conveyor belt, and tighten them in turn to connect the high-pressure water pipe, line plug and pressure pump respectively.
When joining, all mesh joints should be cut, and the glue on the surface should be scraped off, the root wire of the steel cord should be made into a slope angle grinder, and the original surface of the cord should be removed and Rough, clean polished surfaces. Lay a layer of clean plastic film on the surface of the lower heating plate, and then lay a layer of rubber material, so that the rubber material matches the slope of the joints at both ends. Apply glue to the wire lap to ensure that the glue is evenly applied. Apply glue to make the glue consistent with the slope at both ends, and apply a layer of plastic film on it to complete the laying of the steel cord conveyor belt joint and the ring steel wire.
The above is the connection method of steel cord conveyor belt. I hope everyone has to help.

none

None

none

None

Let’s work hard and get on quickly—the construction of subsidiary projects in the new district is in full swing

2022-06-21

Do you know how to extend the life of the layered conveyor belt?

2022-06-20

Wear-resistant ceramic composite pipes are widely used in a variety of industries

2022-06-24

Application details of three-in-one ceramic liner in different industries

2022-06-24